Industrial Electrician

I was running snaptrack, installing handrail LED Lights, wall mounted lights and ceiling mounted lights. All LED lights. I fabricated plates for these lights and supports using uni strut. I assembled lights. I was fabricating snap track to make offsets and 90 degree turns. I was installing cable tray as according to the prints of 12", 18", 24", 36" and 48" cable tray. Using a Hilti gun to install studs on beams. I also did grounding when needed from raceway to raceway.

Industrial Electrician

Running snaptrack, pulling power cables and Instrumentation cables while climbing scaffles to get the wire in raceways of Cable Tray and Snap Track.

Industrial Electrician

I was Grounding 4/O cables to the ceiling ground bar of the E house to the cabinet with crimper lugs using a crimper. I was Terminating cables from 16 awg to 750s. I was running 1/2", 3/4", 1 "EMT pipe from cabinet to cabinet. I was installing raceways of gutter boxes.

Industrial Electrician

I was installing Blast Proof buildings in Shell. We would bolt it together. We would connect the plumbing, tile, electrical and cabinets. We installed panel walls. And pull wire in wire trays from section to section.